The short version of actin binding fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-09 and is reviewed periodically as new material appears.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Acetylated heptapeptide form |
| Monoisotopic mass | 888.5 Da | Average mass about 889 Da |
| Appearance | White to off-white solid | Usually supplied as lyophilised powder |
| Solubility class | Highly water soluble | Also dissolves in aqueous buffers |
| Common synonyms | Tbeta4 fragment, thymosin beta-4 (17-23) | Refer to the same sequence |
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Lyophilized peptide arrives as a dry cake that should stay sealed until use. Reconstitution is generally performed with sterile water or a buffered solution, and the resulting liquid should be handled gently to limit mechanical stress. Repeated freeze-thaw cycles are widely described as harmful to short peptides, so dividing a reconstituted batch into single-use portions is a common practice. Laboratories also record the solvent, concentration, and date of preparation on the vial label to keep later measurements traceable.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
== External links == Waksman Scholars introduction to vectors Archived 2008-01-18 at the Wayback Machine A comparison of vectors in use for clinical gene transfer Gene Transport Unit Archived 2007-12-06 at the Wayback Machine
Silica monoliths, on the other hand, are created in a mold, undergo a significant amount of shrinkage, and are then clad in a polymeric shrink tubing like PEEK (polyetheretherketone) to reduce wall effects. This method limits the size of columns that can be produced to less than 15 cm long, and though standard analytical inner diameters are readily achieved, there is currently a trend in developing nanoscale capillary and prep scale silica monoliths.
== Antivenom == The antivenom was developed by a team headed by Struan Sutherland at the Commonwealth Serum Laboratories (CSL) in Melbourne. Since the antivenom became available in 1981, there have been no recorded fatalities from Sydney funnel-web spider bites. In September 2012, it was reported that stocks of antivenom were running low, and members of the public were asked to catch the spiders so that they could be milked for their venom. The venom is taken from the spiders by delicately stroking their fangs and collecting the tiny droplets of the deadly venom. The venom is needed to produce the antivenom. One dose of antivenom requires around 70 milkings from a spider. Funnel web spider antivenom is prepared from the plasma of rabbits immunized with the venom of the male funnel web spider (Atrax robustus). Each vial of the product contains 125 units of antivenom which has been standardized to neutralize 1.25 mg of funnel web spider venom. The product also contains glycine and other rabbit plasma proteins. Funnel web spider antivenom is a purified immunoglobulin (mainly immunoglobulin G), derived from rabbit plasma, which contains specific antibodies against the toxic substances in the venom of the funnel web spider, Atrax robustus. There is evidence to show that the antivenom is effective in the treatment of patients bitten by some other funnel web spiders of the genus Hadronyche (formerly Atrax).
Sources: en.wikipedia.org
== Commercialization == There are several liposome medicines currently available commercially, which helps set the regulatory pathway for immunoliposome therapies. As immunoliposome therapy has progressed in research, big market players in pharmaceutical research and manufacturing have invested in the development of these therapies. A relevant example of this is a phase I/II trial that examined the effectiveness of PDS0101 in combination with pembrolizumab, an immune checkpoint inhibitor (sold under the brand name Keytruda). The study is funded by PDS Biotechnology and in partnership with Merck. The purpose of the study is to determine the effectiveness of PDS0101 + pembrolizumab in shrinking tumors in patients with virus-related oropharyngeal cancer tumors in humans. PDS0101 is a peptide-based vaccine that aids in the immune response to kill tumor cells. The study also relies on pembrolizumab monoclonal antibodies to help the body's immune system attack the cancer and interfere with the spread of tumor cells. Although immunoliposome therapy exhibits clinical and commercial promise, there are several known challenges in the translation from laboratory studies to clinical studies and ultimately to commercialization. One obstacle is that immunoliposome therapy is limited by having a short half-life and retention time once it reaches the tumor microenvironment. Additionally, immunoliposome therapies are often individualized which requires close clinical monitoring and comprehensive evaluation methods.
Mass spectrometry Macromolecular crystallography Neutron diffraction Proteolysis Nuclear magnetic resonance spectroscopy of proteins (NMR) Electron paramagnetic resonance (EPR) Cryogenic electron microscopy (cryoEM) Electron crystallography and microcrystal electron diffraction Multiangle light scattering Small angle scattering Ultrafast laser spectroscopy Anisotropic terahertz microspectroscopy Two-dimensional infrared spectroscopy Dual-polarization interferometry and circular dichroism Most often researchers use them to study the "native states" of macromolecules. But variations on these methods are also used to watch nascent or denatured molecules assume or reassume their native states. See protein folding. A third approach that structural biologists take to understanding structure is bioinformatics to look for patterns among the diverse sequences that give rise to particular shapes. Researchers often can deduce aspects of the structure of integral membrane proteins based on the membrane topology predicted by hydrophobicity analysis. See protein structure prediction.
Parafluorofentanyl (4-fluorofentanyl, para-fluorofentanyl, pFF) is an opioid analgesic analogue of fentanyl developed by Janssen Pharmaceuticals in the 1960s. Parafluorofentanyl was sold briefly on the US black market in the early 1980s, before the introduction of the Federal Analog Act which for the first time attempted to control entire families of drugs based on their structural similarity rather than scheduling each drug individually as they appeared. Parafluorofentanyl is made by the same synthetic route as fentanyl, but by substituting para-fluoroaniline for aniline in the synthesis. Side effects of fentanyl analogs are similar to those of fentanyl itself, which include itching, nausea, and potentially serious respiratory depression, which can be life-threatening. Fentanyl analogs have killed thousands of people throughout Europe and the former Soviet republics since the most recent resurgence in use began in Estonia in the early 2000s, and novel derivatives continue to appear. In 2020, the Drug Enforcement Agency warned about the increasing prevalence of parafluorofentanyl in Arizona.
=== Melanoma === For high-risk melanoma, it is used as an adjuvant therapy to surgery in some countries. It was first approved for the purpose by FDA on 29 March 2011, based on a single phase III trial. The usage remains controversial — frequency of severe side-effects is high, overall survival benefits substantially vary across different trials, and there is no consensus on the dosage regimen. Meta-analyses have suggested that the drug might be more helpful for patients with ulcerated primary lesion.
Sources: en.wikipedia.org
No. TB-500 is a short synthetic peptide matching residues 17 to 23 of thymosin beta-4, while the parent protein contains 43 residues. The fragment lacks the rest of the protein sequence, so the two are related but not identical.
It consists of leucine, lysine, lysine, threonine, glutamic acid, threonine, and glutamine in that order. The N-terminal leucine is usually acetylated in the forms described in catalogues.
Controlled human data is limited, and most published findings come from cell culture or animal work. This makes it difficult to state clinical effects with confidence.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.