Everything below concerns actin binding. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-03-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
A safety review reported that deaths from tyramine/MAOI-induced hypertension are extremely rare and that no deaths from MAOI-induced hypertension had been reported in the medical literature for several decades. Phenelzine should not be combined with drugs that have significant serotonin reuptake inhibition or significant serotonin-releasing activity, because of the risk of serotonin toxicity. Examples include selective serotonin reuptake inhibitors (SSRIs), serotonin–norepinephrine reuptake inhibitors (SNRIs), clomipramine, imipramine, MDMA, and certain analgesics such as meperidine, tramadol, methadone, tapentadol, dextromethorphan, dextropropoxyphene, pentazocine, and levorphanol. This serotonin-toxicity mechanism is distinct from the usual caution about overlapping MAO-inhibiting agents. Classic MAOI-to-classic MAOI overlap is not expected to cause serotonin toxicity by itself, although routine long-term coadministration is generally avoided because of limited safety data and lack of usual therapeutic rationale. Indirect monoamine-releasing sympathomimetics without significant serotonergic activity, such as ephedrine and pseudoephedrine, are not absolute contraindications, but may increase blood pressure and are generally avoided or used only cautiously at reduced doses with monitoring. Pseudoephedrine is considered less potent than ephedrine, and ephedrine less potent than amphetamine.
Human rights in Ba'athist Syria were effectively non-existent. The government's human rights record was considered one of the worst in the world. As a result, Ba'athist Syria was globally condemned by prominent international organizations, including the United Nations, Human Rights Watch, Amnesty International, and the European Union. Civil liberties, political rights, freedom of speech and assembly were severely restricted under the neo-Ba'athist government of Bashar al-Assad, which was regarded as "one of the world's most repressive regimes". The 50th edition of Freedom in the World, the annual report published by Freedom House since 1973, designated Syria as "Worst of the Worst" among the "Not Free" countries. The report listed Syria as one of the two countries to get the lowest possible score (1/100). During the Ba'ath Party's rule, several repressive political laws were passed, such as Law No. 49, Revolution Protection Law, Economic Sanctions Law and Arab Socialist Ba'ath Party Security Law. The 1963 coup d'état by the Military Committee of the Syrian Ba'ath party propelled the neo-Ba'athists into power, allowing them to establish a totalitarian state in Syria. Following a period of intra-party power-struggles that culminated in the 1970 coup, General Hafez al-Assad became the Syrian President; establishing a hereditary dictatorship of the Assad family.
Abiotic factors that can damage plants include heat, freezing, flooding, lightning strikes, ozone gas, and pollutant chemicals. Heat can kill any plant, given a sufficient temperature. Alpine plants tend to die at around 47 Celsius; temperate plants at around 51 Celsius; and tropical plants at nearly 58 Celsius: but there is some overlap depending on species. Similarly among cereal crops, temperate barley and oat die at around 49 Celsius, but tropical maize at 55 Celsius. Freezing affects plants variously, according to each species' ability to resist frost damage. Many forbs, including many garden flowers, are tender with little tolerance to frost, and die or are seriously damaged when frozen. Many woody plants are able to supercool, with tough buds and stems containing molecules that lower the freezing point or help to prevent the nucleation of ice crystals, and cell walls that mechanically protect cells against freezing. Flooding of soil quickly kills or injures many plants. The leaves become yellow (chlorosis) and die, progressively up the stem, within about five days after the roots are flooded. The roots lose the ability to absorb water and nutrients. Lightning strikes kill or injure plants, from root crops like beet and potato, which are instantly cooked in the ground, to trees such as coconut, through effects such as sudden heat and pressure shock waves created when water inside the plant flashes to steam. This can rupture stems and scorch any plant parts.
Sources: en.wikipedia.org
== Further reading == DOE Fundamentals Handbook: Nuclear Physics and Reactor Theory Volume 1 (PDF). U.S. Department of Energy. January 1993. DOE-HDBK-1019/1-93. Archived from the original (PDF) on 2014-03-19. Retrieved 2012-01-03. DOE Fundamentals Handbook: Nuclear Physics and Reactor Theory Volume 2 (PDF). U.S. Department of Energy. January 1993. DOE-HDBK-1019/2-93. Archived from the original (PDF) on 2013-12-03. Retrieved 2012-01-03. Bulgac, Aurel; Jin, Shi; Stetcu, Ionel (2020). "Nuclear Fission Dynamics: Past, Present, Needs, and Future". Frontiers in Physics. 8 63. arXiv:1912.00287. Bibcode:2020FrP.....8...63B. doi:10.3389/fphy.2020.00063.
Leumorphin, also known as dynorphin B1–29, is a naturally occurring endogenous opioid peptide. Derived as a proteolytic cleavage product of residues 226-254 of prodynorphin (preproenkephalin B), leumorphin is a nonacosapeptide (29 amino acids in length) and has the sequence Tyr-Gly-Gly-Phe-Leu-Arg-Arg-Gln-Phe-Lys-Val-Val-Thr-Arg-Ser-Gln-Glu-Asp-Pro-Asn-Ala-Tyr-Ser-Gly-Glu-Leu-Phe-Asp-Ala. It can be further reduced to dynorphin B (dynorphin B-13) and dynorphin B-14 by pitrilysin metallopeptidase 1 (formerly referred to as "dynorphin-converting enzyme"), an enzyme of the endopeptidase family. Leumorphin behaves as a potent and selective κ-opioid receptor agonist, similarly to other endogenous opioid peptide derivatives of prodynorphin.
In organic chemistry, a nitrile is any organic compound that has a −C≡N functional group. The name of the compound is composed of a base, which includes the carbon of the −C≡N, suffixed with "nitrile", so for example CH3CH2C≡N is called "propionitrile" (or propanenitrile). The prefix cyano- is used interchangeably with the term nitrile in industrial literature. Nitriles are found in many useful compounds, including methyl cyanoacrylate, used in super glue, and nitrile rubber, a nitrile-containing polymer used in latex-free laboratory and medical gloves. Nitrile rubber is also widely used as automotive and other seals since it is resistant to fuels and oils. Organic compounds containing multiple nitrile groups are known as cyanocarbons. For the organic compounds of the form R−N+≡C− instead of R−C≡N, they are referred to as isonitriles, or isocyanides. Inorganic compounds containing the −C≡N group are not called nitriles, but cyanides instead. Though both nitriles and cyanides can be derived from cyanide salts, most nitriles are not nearly as toxic.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.